My Account

Versa Pod Installation Instructions

Posted by on 8/17/2016
The following assembly instructions are
for mounting the Versa Pod
® on the front
of the receiver for all AK variants.

BHA Mfg of our Vepr Forearm

Posted by Administrator on 4/28/2015
The following shows the steps we go through in-house to make our Vepr forearms.


Vepr-12 Stock Swap

Posted by Administrator on 3/28/2015

The following shows converting a Vepr-12 from a folding skeletal stock to one of our SVD Dragunov expandable stocks.


Vepr Forearm Installation

Posted by Administrator on 3/20/2015
  The following assembly instructions are for both
  the Vepr Standard Gas Block Forearms and the
  Integrated Gas Block Forearms.

Gun Build Series III

Posted by Administrator on 2/17/2015
.
This is the 3rd series in the gun build, following Series II that was posted on 2/3/15.

The first picture shows the barrel pin hole being machined using an end mill.

Flat Back Receiver Stock Installation

Posted by Administrator on 2/14/2015
.
The following stock assembly instructions are for Kalashnikovs with a flat back receiver.

It covers both expandable and fixed
stocks, for the Vepr, FPK, Sagia (Converted), and others.

Gun Build Series II

Posted by Administrator on 2/3/2015
.
This is the 2nd series in the gun build, following Series I that was posted on 1/29/15.

The first picture here shows riveting in the rear trunnion using the jig pictured earlier.

Production of OEM Components

Posted by Administrator on 2/2/2015
As a manufacturer, we’ve learned to focus on one core competency, and ours is assembly.
For this reason, we are reliant on outside contractors to produce components using tooling we own.

Vepr Slant Back Stock Installation

Posted by Administrator on 1/31/2015
.
The following assembly instructions are for the Vepr Slant Back Expandable Stock only.

After unpacking the stock and removing the existing stock from your Vepr, you'll start with Step 1.

Gun Build Series I

Posted by Administrator on 1/29/2015
.
We're going to be posting a series of blogs that show a step by step build of some of our firearms.

This 1st one focuses on riveting the front trunnion into the receiver of
our BHAK54.